When it comes to the quality of your installation, it’s not the best decision to take any shortcuts. When you are installing your own equipment, there are many things to consider. I’m going to list some things that are essential in my opinion to use, or at least have around when doing an installation. I, myself keep all of these items in my installation bag at all times.
Known to many as dampening material, this stuff is the equivalent of jumping out of an airplane and landing on a cloud. A cloud made of Butyl rubber, that is. Buy a bunch of deadening material and load your car up. You’ll feel like you’re in a Lexus in no time.
For when your speakers can’t take a beating, there are bass blockers. Throw these in line with your positive connection to each speaker or tweeter, and never again will you need to worry about nasty distortion blaring through your beautiful jazz.
Guaranteed to make you look like a pro. Next time you’re wiring your friend’s stereo up, slap a piece of this over each connection and torch it with a lighter. Next, watch in awe as people start blowing your phone up with phone calls from your friend’s friends.
The next best thing to soldering. When you’ve run out of electricity and you just can’t seem to find the blowtorch Dad stashed somewhere short after Christmas, save some time and just use butt connectors. They’re quick and they hold a wire connection for a lifetime.
Use these often. Tie your wires in bundles and run them parallel to one another for a clean installation that won’t be a mess if you need to get back into it later. Nothing is worse than becoming unorganized during your install and wasting precious beer drinking time.
You may not need these for every install, but I swear they come in handy more often than you would think. Mounting an amp? Mounting some speakers? Attaching a double DIN cage to your new receiver? You’ll probably need some of these screws.
Single pole double throw relays. My longtime friends. I use these in every installation that requires more than one accessory to be triggered off a head-unit. Your decks remote wire will only put out a few volts, which isn’t enough when trying to run multiple amps, processors, etc. Throw a relay in the mix and shoot a wire straight to the battery connection, and you’ve got one strong signal.
Be Prepared for Any Install
Low and behold, there it is. The 7 essential accessories that you mustn’t find yourself without. You can find almost all of this stuff at your local hardware store. Your installation will be of much better quality and build if you use these key ingredients.